- Menu
-
- English
Views: 103 Author: Site Editor Publish Time: 2022-09-13 Origin: Site
Cabinets in the server room, whether internal or external, should set a certain cleaning cycle, if not for regular cleaning and maintenance, will cause different degrees of failure, if it leads to other equipment damage, the cost of overhaul will be very high. Today to give you a brief explanation, the cabinet in the machine room cleaning and dust removal skills.
As the entire equipment of the basic hardware, is the easiest to accumulate dust. When cleaning the motherboard, remove all plug-ins, remove the fixed motherboard screws, remove the motherboard, with a wool brush to brush away the dust in various parts. When operating, the force should be moderate, so as not to damage the surface patch components. If the dust is too much, anhydrous alcohol can be used to clean. If the motherboard has a temperature measurement components, to protect in advance. If too much dust in the slot available hair dryer for cleaning.
Plug surface can be cleaned with the method of cleaning the motherboard, if the plug part of the oxidation, available rubber carefully wipe the gold finger clean, inserted back into the motherboard, in the slot on both sides with hot melt glue to fill the gap to prevent dust in the process of use and oxidation phenomenon.
Fan blades inside, usually accumulate a lot of dust, you can use your hands against the blades one by one with a brush to dust, and then use a damp cloth to wipe the inside of the fan machine frame. You can also add some lubricant to the shaft to improve its performance and reduce noise. For the structure of the fan and the heatsink can be separated, can be disassembled and cleaned with water or blowing air with a brush. For the non-separable heatsink, use a hard brush to clean the dust in the gap. The cleaned heatsink must be thoroughly dried before re-installation, and the re-installed heatsink is recommended to be smeared with an appropriate amount of heat-conducting silicone grease to enhance thermal conductivity.
For the case surface dust, wipe with a damp cloth wrung out. Note that the wet cloth as dry as possible to avoid residual water stains, after the completion of the available hair dryer.
Generally use a brush to remove the floating soil, and then use the hair dryer to clean. If there is oil, available degreasing cotton ball with anhydrous alcohol to remove.
Power supply is very easy to accumulate dust equipment, and the temperature is seriously affected. If you are not a professional, do not disassemble it privately. Available hair dryer strong gear against the power supply air inlet to blow out the dust, and use a hard brush across the fan screen to clean the fan blades.
Any equipment requires regular maintenance to extend the service life.
